|
Addtime：2013-07-22
1, the power light does not shine; boot other light does not shine; correction lights, position lights, depth lamps have an immortal: the machine is faulty, please contact your supplier
2, suspension lights; paper / ribbon lights: runs out of paper or not properly installed
3, printing stops, pause lights, paper / ribbon lights flash: ribbon run or installed incorrectly
4, printing stops, pause lights, headlights flash print: Print Head is not completely closed
5, printing stops, pause lights, headlights bright print: The print head is overheated, shutdown, pause printing
6, the paper printing area are IOUs: The print head broken, replace the print head
7, printed label records are missing: label sensor did not adjust well
8, the vertical lines on the label: The print head is dirty, after shutdown with an alcohol swab to clean the print head
9, there are differences in depth about print: The print head pressure balance around a problem
10, there are oblique IOUs: wrinkled ribbon
11, Changbai strip in several tabs: wrinkled ribbon
12, the ribbon wrinkle: ribbon path is incorrect; installation uneven or select an incorrect print depth, pressure 13, one to three labels positioning allowed: Switch printheads, labels are not allowed to install
14, the computer to send data to the printer, the printer does not move, DATA light flashes off after: Check the printer and the computer serial port communication parameters are the same.
15, the computer to send data to the printer, the printer does not move, DATA light does not flash: The printer does not receive data, check the cable, or the printer interface should be a problem, serial printer self-test is normal, but not on-line printing, there may be the motherboard U51 (105S) element (Max232) Manifold damaged. For S500, U28 on the motherboard may be damaged.
16, the label has not been cut under the knife: cutting mode is not set; cutter plug loose
17, the cutter was not completely cut off the label: cutter dirty; cutter blunt; used for too long, mechanical wear
18, the cutter has a label; cutter stuck: turning on the cutter, the label exit. Boot the cutter reset, then reset the paper loaded
19, printing stops, paper / ribbon lights, suspension lights, data lights: out of paper while printing, the machine has data, change paper lamps can be suspended after the press to continue printing.
20, skipped a label printing, continue printing: This label and a label on the distance between the abnormal, the machine properly
21, Power Light off: No power, power fuse is blown
22, print headlights lit: Printhead Sensor newly installed file version is loose or not another sign Calibrate.
23, the label go awry: Adjust the printhead pressure to both sides even by force
24, the label is no longer accurate: Clean Sensor, regulating Media Sensor and Calibrate once
25, poor print: print head pressure adjustment or Darkon (grayscale).
|